Deteksi Keausan Alat pada Proses Pengeboran Sumber Alam
Keywords:
Change point detection, drilling, mean time between failures.
Abstract
In this paper we applied change point detection methods for failures detection in the drilling process. We calculated the change points on three drilling parameters, i.e., the weight on bit, top drive torque and rate of penetration. Using the concept of reliability, we measured the time between change points as the time between failures. The minimum of mean time between change points from those three parameters is suggested to be the time for monitoring the drilling process.Metrics
Metrics Loading ...
Section
Articles
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
Â
